Wyrestorm NHD-200-RX - HDMI over IP WUXGA, H.264 Decoder, PoE, RS-232, CEC, Matrix

The NHD-200-RX Decoder offers matrix switching functionality when paired with an NHD-200-TX encoder for multi-format input transmissions of DVI, HDMI, Component and VGA including HDMI and analog audio breakout outputs.
The NetworkHD 200-Series is WyreStorm’s current flagship HD-Over-IP AV distribution platform, sharing many of the same benefits as its smaller sibling, the 200-Series offers configurable high quality, low-bandwidth H.264 compression supporting 1920x1200@60fps at 40Mb/s and below, and instant switching between sources with both high and low latency modes, but with powerful video wall functionality over LAN that makes it the best all-round solution for commercial AV installations.

Key Features:
- Multi-format HD over IP AV distribution solution utilising H.264 compression for matrix switching
- Matrix switching functionality
- HDMI and analog audio breakout outputs
- Instant switching between video sources with both high quality and low latency modes
- Plug and Play configuration with auto IP addressing and Bonjour discovery of components

Features
- Highly scalable, high quality, low-bandwidth solution using the most efficient compression technologies to allow for very large commercial AV deployments
- Matrix switching functionality
- Compatible with NHD-000-CTL controller and NHD-200-TX encoder
- Plug and Play setup with quick networking configuration and auto discovery of components
- Quick Sync technology for virtually instantaneous seamless switching
- Full RS232 control of connected displays and CEC One-Touch Play
- Major control systems drivers available including the WyreStorm Enado Control System
- Supports video previewing on a PC or third party device. Capable of outputting two simultaneous IP streams. One large IP stream supports a streaming resolution from 480p @ 60Hz to 1920 x 1200 @ 60Hz to view a video on the decoder. The other small one supports resolutions of 352 x 288 @ 5Hz to easily preview a video from the encoder on a PC or Mac
- Use with the new NetworkHD controller (NHD-000-CTL) for matrix control and management via the LAN, as well as for allowing control from third party control system such as AMX, Crestron, Control4, RTI & Enado.
- Supports PoE to be remotely powered by compatible power source equipment, eliminating the need for a nearby power outlet
- Standards-based H.264/MPEG-4 AVC video compression
- Full PC control suite available free of charge at wyrestorm.com
- Supports HDCP
- Supports the H.264 features baseline profile, main profile and high profile
- Auto input format detection
- Configurable encoding bit rate up to 40 Mbps
- Supports PoE for remote powered from the switch, eliminating the need for a nearby power outlet
- Supports AutoIP, zero-configuration networking (zeroconf), a set of technologies that automatically assigns dynamic IP addresses to the Encoder on start-up and a server-less method of choosing IP addresses

In the Box:
1 x NHD-200-RX Main Unit
1 x Power Adapter (12V 1A DC)
1 x Detachable Plug
3 x Phoenix Conn. (Male, 3.5 mm, 3 pins)
2 x Mounting Brackets
1 x Quickstart guide